Rudyk, O.Yu.Voytyuk, I.S.Gerasymchuk, M.I.Nikolayenko, V.V.2024-11-042024-11-042024Rudyk O. Yu. Computer simulation of the stressed and deformed state of motor vehicle parts / O. Yu. Rudyk, I. S. Voytyuk, M. I. Gerasymchuk, V. V. Nikolayenko // Стан, досягнення та перспективи інформаційних систем і технологій. Матеріали ХХIV Всеукраїнської науково-технічної конференції молодих вчених, аспірантів та студентів. Одеса, 18-19 квітня 2024 р. – Одеса: Видавництво ОНТУ, 2024 р. – С. 68-70.https://elar.khmnu.edu.ua/handle/123456789/16975In order to increase efficiency, prevent breakdowns, extend the service life and properly analyze the operation of structures under deformations of any magnitude with very high accuracy, it is suggested to use mathematical modeling of individual units and parts of motor vehicles in the SolidWorks program and its SolidWorks Simulation application.Mathematical and computer modeling of complex processes has advantages over other traditional calculation methods. Therefore, in this study, the SolidWorks program and its SolidWorks Simulation application were used to replace the material of the primary shaft of the gearbox of the GAZ-24 car (alloy steel) with structural steel (after chemical and thermal treatment), which is cheaper and more accessible in repair shops.enmodelingSolidWorks Simulationgearboxprimary shaftvon MisesURESESTRNFOSТези доповідей378.147:629.331