Lubohynets, O.V.Baranov, I.I.Gereta, M.M.Dytynyuk, V.O.Fedoryshyn, S.I.2023-11-272023-11-272023Using SolidWorks in modern education and science / O. Yu. Rudyk, I. I. Baranov, M. M. Gereta, V. O. Dytynyuk, S. I. Fedoryshyn // Стан, досягнення та перспективи інформаційних систем і технологій : матеріали XXIII Всеукраїнської науково-технічної конференції молодих вчених, аспірантів та студентів. – Одеса, 20-21 квітня 2023 р. – Одеса : Видавництво ОНТУ, 2023 р. – С. 125-126.https://elar.khmnu.edu.ua/handle/123456789/14676The main feature of modern graphic training of engineers in this specialty is 3D modelling, since information models are present at all stages of the life cycle of car parts. Therefore, a technology for teaching engineering disciplines was developed, which uses a single tool – the basic CAD/CAM/CAE/PDM-system SolidWorks as a cross-cutting means of learning in all technical disciplines of the curriculum: solid-state 3D-design in the first courses of study, engineering calculations (the SolidWorks Simulation application) – on the latest.The use of the SolidWorks CAD/CAM/CAE/PDM system and its SolidWorks Simulation application for solving problems of the mechanics of a deformed solid body in the specialty "Automotive transport" is under consideration: the performance of the satellites of the front axle differential of the LuAZ car, impact on the stability of the steering bipod of the LiAZ bus, the possibility of optimizing the clutch lever of the tractor.enSolidWorkscarscalculation of detailsТези доповідей378.147:629. 331