Метод самооптимізуючого контролю заряду та розряду акумуляторної батареї
Вантажиться...
Дата
2024
Назва журналу
Номер ISSN
Назва тому
Видавець
Хмельницький національний університет
Анотація
У статті розроблено структурну схему, яка реалізує метод самооптимізуючого контролю заряду та розряду
акумуляторної батареї. Для контролю напруги використовується ПІД - регулятор із двома додатковими полюсами.
Для керування струмом використовуємо контроль пікового струму. Перевага цього типу контролю полягає в
обмеженні максимального значення вхідного струму системи. При живленні від батареї цей тип керування діє як захід
безпеки, запобігаючи надмірному споживанню струму навантаженням.
Вхідний струм системи (або струм через котушку, оскільки вони рівні, коли працює ) порівнюється з керуючим
струмом таким чином, що коли струм стає більшим за опорний струм, керуючий сигнал вимикача деактивується. Таким
чином, діє як граничне значення струму
The article develops a block diagram that implements a method of self-optimizing control of the charge and discharge of a battery. A PID controller with two additional poles is used to control the voltage. For current control, we use peak current control. The advantage of this type of control is that it limits the maximum value of the input current of the system. When powered by a battery, this type of control acts as a safety measure, preventing excessive current consumption by the load. The input current of the system (or the current through the coil, since they are equal when is operating) is compared with the control current in such a way that when the current becomes greater than the reference current, the control signal of the switch is deactivated. Thus, acts as a current limit
The article develops a block diagram that implements a method of self-optimizing control of the charge and discharge of a battery. A PID controller with two additional poles is used to control the voltage. For current control, we use peak current control. The advantage of this type of control is that it limits the maximum value of the input current of the system. When powered by a battery, this type of control acts as a safety measure, preventing excessive current consumption by the load. The input current of the system (or the current through the coil, since they are equal when is operating) is compared with the control current in such a way that when the current becomes greater than the reference current, the control signal of the switch is deactivated. Thus, acts as a current limit
Опис
Ключові слова
контроль пікового струму, метод самооптимізуючого контролю заряду та розряду акумуляторної батареї, peak current control, a method of self-optimizing control of battery charge and discharge
Бібліографічний опис
Мартинюк В. Метод самооптимізуючого контролю заряду та розряду акумуляторної батареї / В. Мартинюк, М. Швець // Вимірювальна та обчислювальна техніка в технологічних процесах. – 2024. – № 4. – С. 221-224.