Investigation of a universal puller of bearings with SolidWorks
Вантажиться...
Дата
2022
Автори
Rudyk, Oleksandr Yuhymovych
Kaplun, Pavlo Vitaliyovych
Gonchar, Volodymyr Antonovych
Назва журналу
Номер ISSN
Назва тому
Видавець
Дніпро: НМетАУ
Анотація
The bearing is a rather complicated and expensive part, so it is better to use a special stripper to avoid damage, chips and nicks. Although it is possible to remove the bearing by knocking out the inner holder, but this requires a sleeve clearly the size of the inner part of the bearing. And if the bearing is stuck, it is practically impossible and technically incorrect to remove it in this way. Thus, in any car service that deals with the chassis of the car, there must be a set of bearing removers
Опис
For the considered delight of the universal bearing stripper, the maximum force that will not lead to safety violations (with the minimum allowable margin of safety [n] = 3) will be 1978 N (for one delight).
Ключові слова
Бібліографічний опис
Rudyk O. Investigation of a universal puller of bearings with SolidWorks / O. Rudyk, P. Kaplun, V. Honchar // Інформаційні технології в металургії та машинобудуванні. ІТММ’2022 : тези доповідей міжнародної науково-практичної конференції (Дніпро, 18 травня 2022 р.) / Міністерство освіти і науки України, Український державний університет науки і технологій, Дніпропетровський національний університет імені О. Гончара, Національний технічний університет «Дніпровська політехніка» та ін. – Дніпро: НМетАУ, 2022. – С. 248-251.